Calibration adjustments (KB-AM004)

AR View

To enter the calibration adjustment mode tap the "ADJUST" button at the bottom of the screen (Fig. 1).

Swiping your finger on the side scale will change your elevation with respect to the model. This will allow you to raise or lower the scene of projections (Fig. 2).

By swiping your finger on the bottom scale, you can adjust orientation in 0.1° increments so you can rotate the scene of projections left or right. The scale is set up with reduced sensitivity to help you make precise adjustments without additional efforts.

When you swipe your finger in any direction across the main section of the screen, your location will change, and the scene around you will shift in the direction you swipe.

The calibration adjustment screen will automatically close when left idle for 3 seconds. You will see a circle form around the “X” button in the top left corner.

Map View

You can also access the calibration adjustment mode from the map view by tapping the “ADJUST” button at the bottom of the screen (Fig. 3).

In the map view, the calibration adjustment function enables you to make adjustments to your location. 

You can adjust orientation in 0.1° increments so you can rotate the scene left or right. The scale is set up with reduced sensitivity to help you make precise adjustments without additional efforts.

The calibration adjustment screen will automatically close when left idle for 3 seconds. You will see a circle form around the “X” button in the top left corner.

Note: you can perform a typical pinch-to-zoom gesture to zoom in to the overhead map.

Fig. 1

Fig. 2

Fig. 3